Table of Contents
Advertisement
Auto MDI/MDI-X
All of the twisted pair ports on the switch are auto-MDI and IEEE
802.3ab-compatible. When a port's speed and duplex mode are set
through Auto-Negotiation, the port uses the auto-MDI feature to
automatically configure itself as MDI or MDI-X when connected to an
end-node. Consequently, you can use either a straight-through or
crossover twisted pair cable when connecting any network device to a
port.
LEDs
The system and port LEDs on the front panel of the AT-GS916 and AT-
GS924 switches display the switch and its port status information. Each
port has four LEDs.
AT-GS916
AT-GS924
Table 1 describes the system and port LEDs on the AT-GS916 and
AT-GS924 Gigabit Ethernet switches.
LED
POWER
10
100
AT-GS916 and AT-GS924 Gigabit Ethernet Switches Installation Guide
AT-GS916
10/100/1000Base-T Gigabit Ethernet Switch
POWER
1
2
3
4
5
6
7
POWER
1
2
3
4
5
6
7
8
9
10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Figure 3 Port LEDs
Table 1 System and Port LEDs
State
Description
Green
The switch is powered ON.
OFF
The switch is powered OFF.
Green
The port is operating at 10 Mbps.
Green
The port is operating at 100 Mbps.
OFF
When both 10 and 100 LEDs are OFF,
the port is operating at 1000 Mbps.
10
1000
100
ACT
FDX
8
9
10
11
12
13
14
15
16
10
1000
100
ACT
FDX
13
Advertisement
Table of Contents
