Cabling Notes; Figure 1-3 Front Panel Usb Ports - Fujitsu Sparc Enterprise T2000 Installation Manual

USB Port3
USB Port2
FIGURE 1-3

Cabling Notes

Minimum cable connections for the SPARC Enterprise T2000 server:
■
■
■
■
■
System controller (SC) management ports: There are two SC management ports
■
for use with the ALOM CMT system controller.
■
■
■
Ethernet ports are labeled NET0, NET1, NET2, and NET3. The Ethernet interfaces
■
operate at 10 Mbps, 100 Mbps, and 1000 Mbps. The transfer rates for the Ethernet
ports are given in
TABLE 1-1
Connection Type
Ethernet
Fast Ethernet
Gigabit Ethernet
6 SPARC Enterprise T2000 Server Installation Guide • April 2007
Front Panel USB Ports
At least one system on-board Ethernet network connection (NET port)
The system controller serial management port (SER MGT port)
The system controller network management port (NET MGT port)
Power cables for the two system power supplies
The SC serial management port (labeled SER MGT) uses an RJ-45 cable and is
always available. This is the default connection to the ALOM CMT system
controller.
The SC network management port (labeled NET MGT) is the optional
connection to the ALOM CMT system controller. This port is not available until
you have configured network settings for the system controller (through the SC
serial management port). See
Management Port" on page
RJ-45 cable for a 10/100 BASE-T connection. This port does not support
connections to Gigabit networks.
See the SPARC Enterprise T2000 Server Overview for more information.
TABLE 1-1
Ethernet Connection Transfer Rates
IEEE Terminology
10BASE-T
100BASE-TX
1000BASE-T
"Enabling the System Controller Network
37. The SC network management port uses an
.
Transfer Rate
10 Mbit/sec
100 Mbits/sec
1000 Mbit/sec