To Power On The System For The First Time - Fujitsu Sparc Enterprise T2000 Installation Manual

To Power On the System for the First Time

▼
Tip – The serial terminal or a terminal emulator should be connected before you
connect the power cables, or you will not see the system messages. The server goes
into standby mode and the ALOM CMT system controller initializes as soon as the
AC power cables are connected to the power source.
Note – If you are not logged in, ALOM CMT times out after 60 seconds and reverts
to the system console. Type #. to return to the ALOM CMT system controller
prompt. For more information, refer to the Advanced Lights Out Manager (ALOM)
CMT 1.x Administration Guide.
The system controller runs on the 3.3v standby voltage. As soon as AC power is
connected to the system, the system controller powers on, runs diagnostics, and
initializes the ALOM CMT firmware.
1. If you have not already done so, connect a terminal or a terminal emulator (PC or
workstation) to the SC serial management port. Configure the terminal or terminal
emulator with these settings:
9600 baud
■
8 bits
■
No parity
■
1 Stop bit
■
No handshaking
■
Note – When you power on the server for the first time and you do not have a
terminal or terminal emulator (PC or workstation) connected to the SC serial
management port, you will not see system messages. The display times out and
disappears after about 60 seconds. After connecting to the SPARC Enterprise T2000
server with a terminal or terminal emulator, type #. to get to the system controller
console.
2. Turn on the terminal or terminal emulator.
3. Connect the AC power cables to Power Supply 0 and Power Supply 1, and watch
the terminal for system messages.
Chapter 3 Powering On the System 35