Data Port And Cabling Notes; Port Locations; Cabling Notes; Figure 1-5 Locations Of Ports And Connectors On The Rear Panel - Fujitsu SPARC Enterprise T1000 Installation Manual

Data Port and Cabling Notes

Port Locations

FIGURE 1-5
AC in
FIGURE 1-5

Cabling Notes

The following list describes the server's cable connections and ports:
Minimum cable connections for the server:
■
■
■
■
■
System controller (SC) management ports. There are two SC management ports
■
for use with the ALOM CMT system controller.
■
■
8 SPARC Enterprise T1000 Server Installation Guide • April 2007
shows the ports on the server.
Locations of Ports and Connectors on the Rear Panel
At least one system on-board Ethernet network connection (NET port)
System controller serial management port (SERIAL MGT port)
System controller network management port (NET MGT port)
Power cable
The SC serial management port (labeled SERIAL MGT) uses an RJ-45 cable and
is always available. This is the default connection to the ALOM CMT system
controller.
The SC network management port (labeled NET MGT) is the optional
connection to the ALOM CMT system controller. See
Controller Network Management Port" on page
management port uses an RJ-45 cable for a 10/100BASE-T connection. This
port does not support connections to Gigabit networks.
See the SPARC Enterprise T1000 Server Overview for more information.
NET3
SC network management port
NET2
NET1 SC serial management port
NET0
Serial port
31. The SC network
"To Configure the System