Booting The Solaris Operating System; To Boot The Solaris Operating System - Fujitsu Sparc Enterprise T2000 Installation Manual

To understand the various devices and their path names as represented in the
OpenBoot device tree, refer to
full path name and their location or NAC name used to identify their physical
location.
Map of Devices, OpenBoot Path Names, and Locations
TABLE 3-1
OpenBoot Device Path Name
/pci@780
/pci@780/pci@0
/pci@780/pci@0/pci@1
/pci@780/pci@0/pci@8
/pci@780/pci@0/pci@9
/pci@7c0
/pci@7c0/pci@0
/pci@7c0/pci@0/pci@2
/pci@7c0/pci@0/pci@1
/pci@7c0/pci@0/pci@1/pci@0,2
/pci@7c0/pci@0/pci@1/pci@0,2
/pci@7c0/pci@0/pci@1/pci@0
/pci@7c0/pci@0/pci@8
/pci@7c0/pci@0/pci@9

Booting the Solaris Operating System

The Solaris OS is preinstalled on SPARC Enterprise T2000 server on the disk in slot
0. The Solaris OS is not configured (that is, the sys-unconfig command was run in
the factory). If you boot the system from this disk, you will be prompted to configure
the Solaris OS for your environment.

To Boot the Solaris Operating System

▼
1. At the ok prompt, boot from the disk that contains the Solaris OS.
If you know which disk to boot from, skip
46 SPARC Enterprise T2000 Server Installation Guide • April 2007
. The table identifies each of the devices, their
TABLE 3-1
Device
Fire IO Bridge Bus A
PLX 8532 PCI-E Switch A (U0901)
Intel Ophir GBE Chip (U2401)
PCI-E Slot 0 (J2100)
LSI 1064-E SAS Controller (U3401)
Fire IO Bridge Bus B
PLX 8532 PCI-E Switch B (U1501)
Intel Ophir GBE Chip (U2601)
Intel 41210 Bridge Chip (U2901)
PCI-X Slot 0 (J3301)
PCI-X Slot 1 (J3201)
ULI Southbridge Chip (U3702)
PCI-E Slot 1 (J2202)
PCI-E Slot 2 (J2201)
Location Name
IOBD/PCIEa
IOBD/PCI-SWITCH0
IOBD/GBE0
PCIE0
IOBD/SASHBA
IOBD/PCIEb
IOBD/PCI-SWITCH1
IOBD/GBE1
IOBD/PCI-BRIDGE
PCIX0 (J3301)
PCIX1 (J3201)
IOBD/PCIX-IO
PCIE1 (J2202)
PCIE1 (J2201)
Step a and perform Step 2.