Table of Contents
Advertisement
Installation
Installing an Expansion Module
38
This section contains instructions for installing an optional expansion
module in the switch.
Note
For a list of the Allied Telesyn expansion modules supported by
your AT-9006 Gigabit Ethernet Switch and the AT-S26 management
software, refer to the Preface in the AT-S26 Management
Software User's Guide.
Note
For information on cabling specifications for the expansion
module, refer to the Quick Install Guide that is included with the
module.
An optional expansion module package should include the following
items:
# One expansion module
# One quick install guide
# Warranty card
To install an expansion module, perform the following steps:
1. Disconnect the switch's power cord, if attached.
Caution
Disconnect the power cord from the switch before installing an
expansion module. If the switch is connected to a redundant power
supply (RPS), be sure to disconnect the RPS unit from the switch.
Installing an expansion module with the switch powered ON can
damage the module.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord. "
2. Remove a blank faceplate from one of the expansion slots by
unscrewing the faceplates two captive screws, as shown in Figure 8.
Do not remove the blank faceplate if you are not installing an
expansion module in the slot.
10
Advertisement
Table of Contents
