Next Steps - Polycom VMC 1000 Getting Started Manual

Video Media Center - VMC 1000 Getting Started Guide

Next Steps

16
13 From the command line, modify the following network settings, as
required:
— Show system information by entering: show.
— Set the password to enter this serial port interface by entering: set
password (and then enter your password twice to verify).
NOTE: Changing the password here only changes the password for this serial
connection. It DOES NOT change the password for the VMC 1000 Administrator
UI.
— Change the IP address of the VMC 1000 by entering: set lan1 static <IP
address> mask <IP address> gw <gateway address>
— Shut down the server by entering: shutdown.
— Reboot the server by entering: reboot.
— Restore the factory default settings and delete all user data by
entering: restore.
WARNING: The restore command deletes all configuration and video files from the
VMC 1000.
— Show a list of commands by entering: help or ?
— Log out of the VMC 1000 serial port interface by entering: quit
After you have logged into the VMC 1000, use the Administrator interface to
configure your users to broadcast and view programs. For more information
about configuring users, see the Video Media Center - VMC 1000 Administrator
Guide. For more information about user tasks, see the Video Media Center - VMC
1000 User Guide.
Use the following procedure to access these guides and the Getting Started
Guide on the Polycom Customer Support website.
To access VMC 1000 documentation on the Polycom Customer Support website:
Go to www.polycom.com/support.
1
In the menu on the left side of the page, click Network.
2
Under Video Recording, Streaming and Content Management
3
Solutions, click VMC 1000™ Polycom Video Media Center.
Polycom, Inc.