Installing Or Removing A 5.25-Inch Device; Adding A 5.25-Inch Device - NEC Express 5800 TM700 User Manual

Installing or Removing a 5.25-inch Device

This section of the chapter describes how to add and remove 5.25-inch devices. You
can install a CD-ROM/ DVD-ROM/ COMBO DVD-ROM CD-RW Drive, tape backup
unit, or other 5-25 inch devices in the additional 5.25-inch bay. See the installation
instructions included with those items for specific installation information. Before
installing a 5.25-inch device, read section "Preparing the Device" on page 37.

Adding a 5.25-inch Device

1. Remove the right side door. See "Removing the Right Side Door:" on page 6.
2. Remove the front panel. See "Removing the Front Panel:" on page 8.
3. Remove the 3.5/5.25-inch bracket. See "Removing the 3.5/5.25-inch Bracket:"
on page 9.
4. Gently pull on the desired slot cache to remove it, then pull on the metallic shield
to remove it.
5. Slide the 5.25-inch device through the front of the 3.5/5.25-inch bracket, connec-
tors first. Please check that the front of the device is perfectly aligned with the
other installed devices.
6. Secure the four screws (two on each side).
7. Replace the 3.5/5.25-inch bracket. See "Replacing the 3.5/5.25-inch Bracket:" on
page 11.
8. Connect the data cable to the device with the marked edge toward pin 1 of the
drive. See "Cabling the Device" on page 32.
9. Connect the power cable to the drive. See "Cabling the Device" on page 32.
10. Replace the front panel. See "Replacing the Front Panel:" on page 8.
11. Replace the right side door. See "Replacing the Right Side Door:" on page 6.
addittional device. For additional information, refer to the
'Configuring your system' chapter.
TM700 User Guide - Upgrading Your System
Figure 4 - 10 : Adding a 5.25-inch Device
Note: Modify the BIOS Setup program to recognise the
4 - 12