Table of Contents
Advertisement
Installing a Hard Disk Drive
Make sure to install hard disk drives in either slot A or slot C.
DO NOT use Slot B. Doing so may damage the system and
result in serious burns.
1. Refer to the information provided with the hard disk drive for pre-installation
instructions and master/slave/cable select pin configurations. See "Preparing
the Device" on page 4-37.
2. Remove the right side door. See "Removing the Right Side Door:" on page 4-6.
3. Remove the front panel. See "Removing the Front Panel:" on page 4-8.
4. If applicable, disconnect the data and power cables of the installed hard disk
drives.
5. Remove the screw (A) securing the HDD bracket and the 3.5/5.25-inch bracket
together.
TM700 User Guide - Upgrading Your System
Warning
Figure 4 - 18 : HDD Bracket Screw
4 - 20
Advertisement
Table of Contents
