Shifting From Desktop To Tower - NEC Express 5800 TM700 User Manual

Shifting from Desktop to Tower

Your Express5800 TM is equipped with a convertible chassis, which allows you to set
up your computer either as a tower, or as a desktop. Please find below the instructions
needed to turn your desktop computer into a tower system.
1. Remove the right side door. See "Removing the Right Side Door:" on page 4-6.
2. Lay the chassis on its left side.
3. Remove the front panel. See "Removing the Front Panel:" on page 4-8.
4. Remove the 3.5/5.25-inch bracket. See "Removing the 3.5/5.25-inch Bracket:"
on page 4-9.
5. Replace the 3.5/5.25-inch bracket in the tower position. See "Replacing the
3.5/5.25-inch Bracket:" on page 4-11.
Figure 4 - 2 : 3.5/5.25-inch Bracket Tower Position
6. Look on the inside of the front panel for the back of the logo plate. Press on the
four pegs to release the logo plate, and, holding the front panel horizontally,
replace the plate according to the tower configuration.
7. Replace the front panel. See "Replacing the Front Panel:" on page 4-8.
8. Replace the right side door. See "Replacing the Right Side Door:" on page 4-6.
Congratulations, your Express5800 TM is now ready to be used as a tower system!
TM700 User Guide - Upgrading Your System
4 - 5