Table of Contents
Advertisement
Installing or Removing a 3.5-inch Floppy Disk
Drive
This section describes how to remove, replace and add 3.5-inch Floppy Disk Drives
(FDDs). Two 3.5-inch floppy disk drives can be installed in the FDD bracket. If a
floppy disk drive was installed into your system at the factory, it is located in the upper
slot of the bracket.
Removing a 3.5-inch Floppy Disk Drive
To remove the floppy disk drive from the upper 3.5-inch slot of the 3.5/5.25-inch
bracket:
1. Remove the right side door. See "Removing the Right Side Door:" on page 6.
2. Remove the front panel. See "Removing the Front Panel:" on page 8.
3. Remove the 3.5/5.25-inch bracket. See "Removing the 3.5/5.25-inch Bracket:"
on page 9.
4. Remove the three screws (A) securing the floppy disk drive to the bracket (two
on the left side and one on the right side)
5. Slide the floppy disk drive out of the bracket.
6. Set the floppy disk drive aside.
TM700 User Guide - Upgrading Your System
Figure 4 - 12 : Removing the Screws
Figure 4 - 13 : Sliding the Floppy Disk Drive out
4 - 14
Advertisement
Table of Contents
