Buttons Used For Navigating Through The Menus - Integra DTR-5.3 Instruction Manual

Configuring the speakers
(1) Remember the volume level of this noise and then press the
cursor button. The DTR-6.3/5.3 will now emit the pink noise
from the center speaker.
(2) Using the and cursor buttons, adjust the volume level of the
noise from the center speaker so that it is at the same level as that
that was emitted from the front left speaker.
(3) Press the cursor button again. The DTR-6.3/5.3 will now emit
the pink noise from the front right speaker.
Use the and cursor buttons to adjust the volume of the noise
from the front left speaker so that it is the same level as that that
was emitted from the center speaker.
(4) Use the cursor button to select other speakers and adjust the
volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between –12 and
+12 decibels for all speakers in 1-decibel increments.
Press the Return button to return to the main menu.
Press the
Menu button on the front panel or Setup button on the
button to exit the Setup menu.
remote controller
Using the remote controller
1. Press the Test button.
You will hear a pink noise will be emitted
from the front left speaker.
(1) Remember the volume level of this noise
and then press the CH SEL button. The
DTR-6.3/5.3 will now emit the pink noise
from the center speaker.
(2) Using the Level
volume level of the noise from the center
speaker so that it is at the same level as that
that was emitted from the front left speaker.
(3) Press the CH SEL button again. The DTR-6.3/5.3 will now emit
the pink noise from the front right speaker.
Use the Level /
from the front left speaker so that it is the same level as that that
was emitted from the center speaker.
(4) Use the CH SEL button to select other speakers and adjust the
volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between –12 and
+12 decibels for all speakers in 1-decibel increments.
2. Press the Test button to complete the
procedure.
40
/ buttons, adjust the
buttons to adjust the volume of the noise

Buttons used for navigating through the menus

You can change settings in the Setup Menu using the buttons on the
front panel and on the remote controller.
The buttons on the remote controller correspond to those on the
DTR-6.3/5.3 as shown below.
Buttons on remote controller Buttons on DTR-6.3/5.3
Displaying the Main Menu and exiting the menu
Setup
Selecting a menu or menu item
(upper edge of
ENTER button)
(lower edge of
ENTER button)
Setting the value
(left edge of
ENTER button)
(right edge of
ENTER button)
Selecting the menu
ENTER
Returning to the previous screen
Return
Menu
Up
Down
Left
Right
Enter
Return