Navigating Through The Osd Menu - Integra DTR-7.1 Owner's Manual

The On-Screen Display (OSD) menu
OSD
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
Main menu

Navigating through the OSD menu

The explanations here assume you are using the buttons on the
DTR-7.1 when entering the OSD menu. However, you can use the
buttons on the remote controller as well. In addition to the display
of the OSD Menu on your television monitor, the corresponding
menu will also be displayed in the front display on the DTR-7.1.
The buttons on the remote controller correspond to those on the
DTR-7.1 as shown below.
Button on remote controller
OSD/MENU
(upper edge of
ENTER button)
(lower edge of
ENTER button)
(left edge of
ENTER button)
(right edge of
ENTER button)
ENTER
EXIT/RETURN
1.Speaker Setup
1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Bass Peak Level
|ENTER| Quit:|OSD|
Menu
Button on DTR-7.1
Menu
Menu
UP
DOWN
DSP/Preset
(turn the
SSC dial
to the left)
Push To Enter
DSP/Preset
(turn the
SSC dial
to the right)
Push To Enter
DSP/Preset
(press the
SSC dial)
Push To Enter
Exit
Exit
1-1.Speaker Config
a.Subwoofer
b.Front
c.Center
d.Surr L/R
e.Surr Back
f.Surr Back Out :1ch
1. Press the MENU button.
The main menu screen of the OSD menu appears on your TV
monitor.
2. Using the and cursor buttons, select the
menu that you want to enter.
3. Press the ENTER button to enter the selected
menu.
The screen for that menu appears.
4. Using the and cursor buttons, select the
sub-menu that you want to enter, and press
the ENTER button.
Each sub-menu has different settings that can be changed as
desired, and they are all explained below. To change a setting,
first select it using the
change the setting using the
5. Press the EXIT button to set the new settings
and return to the previous menu screen, and
again to return to the main screen.
Note:
Press the MENU button to exit the OSD menu immediately.
If the OSD Menu does not appear
If the monitor is connected to MONITOR OUT (VIDEO) of the
DTR-7.1, then preform the operations given below and set the
OSD output to "Video." (The initial setting is "S Video.")
1. Press the Menu button.
"1. Speaker Setup" appears in the front display.
2. Turn the SSC dial to the right to display "5.
OSD Setup" and press the SSC dial.
"OSD Config?" appears.
3. Press the SSC dial.
"OSD Out: S Video" appears.
4. Turn the SSC dial to the right to display "OSD
Out: Video."
The OSD output changes to "Video."
:Yes
:Small
:Small
:Small
:Small
Quit:|OSD|
Sub menu
and cursor buttons, and then
and cursor buttons.
29