Integra DTR-5.3 Instruction Manual page 10

Front panel facilities
Rec Out, Zone 2, Off, Level / buttons, and Zone 2
indicator (DTR-6.3 only) [60]
The Rec Out and Zone 2 buttons allow you to use the DTR-6.3 to
output to a remote zone (Zone 2) or to another component for
recording (Rec Out). Press the Rec Out button to output the audio
and video signals to a recording component for recording. Press the
Zone 2 button to enjoy the output from the DTR-6.3 in a different
room, which is referred to as the remote zone (Zone 2). When either
button is pressed, the currently selected input source for recording or
outputting to the remote zone is displayed in the front panel display.
If "SOURCE" is displayed, then the same input source as that
selected for the main zone will be output.
To select an input source, press the desired button (Rec Out or Zone
2) and then press one of the input source button within 5 seconds.
That source will be output for recording or viewing in the remote
zone.
To set the output to the source channel, press the desired button (Rec
Out or Zone 2) twice in succession. To turn off the output, press the
Off button. The Zone 2 indicator lights when a signal is output to the
remote zone (Zone 2). When the Zone 2 indicator is off, then either
output to the remote zone is turned off or Rec Out is selected. Press
the Level / buttons to enter the mode for adjusting the volume in
the remote zone (Zone 2).
Note:
The Rec Out and Zone 2 buttons use the same circuit and therefore
cannot be used at the same time. When Rec Out is selected, nothing
is output to Zone 2. When Zone 2 is selected, Rec Out is
automatically fixed to SOURCE.
Speakers A/B buttons (DTR-5.3 only) [44]
Press these buttons to turn on and off speakers systems A and B.
10