OSD Setup and Other Settings
OSD Setup
This menu allows you to customize the OSD Setup Menu to display
in the manner you desire.
To display the OSD Setup menu:
1. Display the main menu.
2. Use the
and
cursor buttons to select "5. OSD Setup" and
then press the ENTER button.
The "OSD Setup" menu appears.
* Menu *****************
1.Speaker Config
5.OSD Setup
2.Speaker Distance
***********************
3.Level Calibration
4.Input Setup
a.Background Color
5.OSD Setup
:Blue
6.Preference
b.Immediate Display
:Normal
Quit:|SETUP|
a. Background Color
Select either Blue, Green, Magenta, or Red as the background color
when the OSD Setup Menu is displayed.
b. Immediate Display
Off: Select to turn off the immediate display of operations.
Normal: Select to display operations in the bottom right corner
of a TV screen with a 4:3 aspect ratio.
Wide: Select to display operations in the bottom right corner of a
TV screen with a 16:9 aspect ratio.
Hint:
If this is set to "Off," the background color will not be displayed
even when there is no video signal input.
VIDEO 1
Preference
To display the Preference menu:
1. Display the main menu.
2. Use the
and
cursor buttons to select "6. Preference" and
then press the ENTER button.
The "Preference" menu appears.
DTR-6.3
* Menu *****************
DTR-5.3
* Menu *****************
a. Headphones Level
You can adjust the volume output from the headphones so that it
matches the level output from the speakers. The headphone volume
can be adjusted between –12 and +12 decibels.
b. Powered Zone 2 (DTR-6.3 only)
Activated: Select when connecting the speakers for the remote
zone (Zone 2) to the ZONE 2 PRE OUT or ZONE 2 SPEAKERS
terminals (using the internal amplifier of the DTR-6.3).
Not Activated: Select when not connecting the speakers for the
remote zone (Zone 2) to the ZONE 2 PRE OUT or ZONE 2
SPEAKERS terminals (not using the internal amplifier of the
DTR-6.3).
c. IR IN Position (DTR-6.3 only)
Use this setting when you have a remote control sensor connected to
the IR IN terminal. The setting in this menu tells the DTR-6.3
whether the remote control sensor is being used for operation of the
DTR-6.3 in the main zone or the remote zone (Zone 2).
Main: Select when you are using the remote control sensor for
operation with the remote controller in the main zone.
Zone 2: Select when you are using the remote control sensor for
operation with the remote controller in the remote zone (Zone 2).
1.Speaker Config
6.Preference
2.Speaker Distance
***********************
3.Level Calibration
4.Input Setup
a.Headphones Level
5.OSD Setup
:
0dB
6.Preference
b.Powered Zone 2
:Not Activated
c.IR IN Position
:Main
Quit:|SETUP|
1.Speaker Config
6.Preference
2.Speaker Distance
***********************
3.Level Calibration
4.Input Setup
a.Headphones Level
5.OSD Setup
:
0dB
6.Preference
Quit:|SETUP|
55