Programming The Commands Of Remote Controllers For Other Devices Into The Remote Controller; Programming Procedure - Integra DTR-5.3 Instruction Manual

Programming the commands of remote controllers for
other devices into the remote controller
2 to 6 inches
(5 to 15 cm )
Send/Learn
indicator
Mode buttons
Enter

Programming procedure

When programming the commands of another remote controller to
the RC-481M remote controller, you must first decide under which
Mode button you want the commands to be linked. In general, you
will select the Mode button that corresponds to the component you
are programming. For example, if you are programming the
functions from a remote controller for a compact disc player, you
would choose the CD Mode button. Then, by pressing the CD Mode
button, the buttons on the RC-481M remote controller will change to
the commands you program here to operate the compact disc player.
After programming which Mode button to use, you will then transfer
the separate commands from the other remote controller over to the
RC-481M remote controller one at a time. Each command is then
programmed to a different button on the RC-481M remote
controller. Any button is programmable for this step except for the
six Mode buttons (RCVR, CD, DVD, MD, TV, and VCR), the two
Macro buttons (Macro 1 and 2), and the Light button.
Even after the commands have been memorized, keep your old
remote controller in a safe place. If for some reason the commands
are lost (e.g., when the batteries run down), it will be necessary to
memorize them once again.
1. Place the remote controller and the remote controller
for the other device facing each other at a distance of 2
to 6 inches (5 to 15 cm) apart.
2. While pressing and holding down the desired Mode
button on the remote controller, press the Enter
button and then release both buttons.
The Send/Learn indicator lights when the Mode button is
pressed and turns off when the Enter button is pressed. When the
indicator turns off, release both buttons. The Send/Learn
indicator lights again.
3. Press and release the button on the remote controller
to which you want to transfer the next command.
You may select any button excluding the eleven ones indicated
in the figure below. When you press the button, the Send/Learn
indicator turns off. When you release the button, the indicator
lights again.
If you press the wrong button by mistake, press that same button
again. The Send/Learn indicator flashes twice, and the remote
controller exits the programming mode.
Macro 1
: Buttons that cannot be programmed.
Light
Macro 2
Mode buttons
69