Selecting The Type Of Audio Input Signal; Temporarily Changing The Speaker Output Levels; To Change The Display Of The Input Source From Tape To Md - Integra DTR-5.3 Instruction Manual

Selecting an Audio Component
Audio Selector

Selecting the type of audio input signal

Press the Audio Selector button on the front panel (or Audio SEL
button on the remote controller) to change the audio mode. Each
time the button is pressed, the mode changes from "Auto" →
"Multich" (only if DVD is selected as the input source) → "Analog"
and back to "Auto."
DTR-6.3/5.3
Auto (automatic detection): With this setting, the DTR-6.3/5.3
automatically detects whether the input signal is digital or analog.
When a digital signal is not input, then the analog signal is played.
This setting only appears if a digital input is selected for the Digital
Input setting at "Input Setup" → "Digital Input" (see page 53).
Multich (Multichannel): Select this setting to play back the multi-
channel input from a DVD player with a 5.1-channel input port. This
setting only appears if "Yes" is selected for the Multichannel setting
at "Input Setup" → "Multichannel" (see page 53).
Analog: Select this setting to play back the input from a source
component connected to analog audio input jacks. With this setting,
even if a digital signal is input from the same component, only the
analog signal will be output.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 and
+12 decibels. Note that the calibration settings will return to the
original settings when the DTR-6.3/5.3 is put in standby.
Using the remote controller:
1. Press the RCVR Mode button.
2. Press the CH SEL button and select
the desired speaker.
3. Press the Level or button to adjust
the volume level.
Tape
Remote controller
RCVR Mode
CH SEL
Audio SEL
Notes:
• You cannot select a speaker if the configuration value of the
speaker is set to "No" or "None."
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the Test button after you set the level, the
current level will be used as the value set via the test tone.
To change the display of the input source from
TAPE to MD
If you connected an MD recorder to the TAPE jacks of the DTR-6.3/
5.3, you can have "MD" appear when the Tape source button is
pressed. By changing the display, when an Integra/Onkyo MD
recorder is -connected, the
enabled.
Changing the display:
Press and hold down the Tape source button until the display
changes from TAPE to MD (approx. 3 seconds).
To return the display to its original setting, perform the same
procedure. This setting is necessary to allow z system functions
for a connected Integra/Onkyo cassette tape or MD recorder.
Level /
TAP
system functions will become
45