Remove The Service Station; Service Station Removal - ENCAD CADJET Service Manual

5. Orient the new Bushing as shown in Figure 5-19 so that the
metal tab on top of the Bushing goes into the Carriage Assembly
first.
6. Push the Bushings in until they snap into place.
7. Perform the Reinstall the Carriage Assembly, Carriage Belt, and
the Frame Tensioner procedures to reinstall the Carriage
Assembly if Carriage was removed.

Remove the Service Station

1. Place the Top Cover in the open position.
2. Move the Carriage Assembly to the left side of the Slide Shaft.
3. Reach into the Right Cover and pull back on the Service Station
release tab located on the far side of the Service Station. See
Figure 5-20.
4. Raise the right side of the Service Station out of the Platen.
5. Lift out the left side of the Service Station from the Platen and
remove the Service Station. Moving the Service Station farther to
the right might be required to release the left side of the Service
Station.
Figure 5-20. Service Station Removal.
CadJet 3D Service Manual
Assembly\Disassembly 5-35