Service Menu - ENCAD CADJET Service Manual

CadJet 3D Service Manual
To perform the Slow Deadband Alignment
1. Select "Utility Menu" from the Main Menu. This brings up
2. Select the "Service Menu" from the Utility Menu. This brings
3. Select the "Calibration Menu" from the Service Menu.
4. The Calibration Menu is shown in Figure 3-23 and this is
3-28 Maintenance
the Utility Menu as shown in Figure 3-18.
up the Service Menu as shown in Figure 3-22.
Figure 3-22. Service Menu.
where the slow deadband test is performed. Select "Slow Db
Test" to run the slow deadband test.