ENCAD CADJET Service Manual page 150

CadJet 3D Service Manual
10. Reinstall the Right Sideplate using a #2 Phillips screwdriver.
Ensure that all cables from inside the Platen are exiting out of the
large hole in the Sideplate.
11. Reinstall the Power Supply Bracket using four screws and a #2
Phillips screwdriver.
12. Perform steps 5 through 14 of the procedures to reconnect the
MPCB.
13. Reinstall the left Foam Block.
14. Reinstall the Left Sideplate Assembly using a #2 Phillips
screwdriver.
15. Perform steps 1 through 4 of the Install the Ink Delivery System
procedures to reinstall the Ink Delivery System.
16. Perform the Install Left, Top, and Right Covers procedures to
install the Left, Top, and Right Covers.
5-50 Assembly\Disassembly