Remove The Carriage Pcb - ENCAD CADJET Service Manual

CadJet 3D Service Manual
13. Once the Idler Pulley Assembly is in position, pinch the belt to hold
the Idler Pulley Assembly in place and pull it into the Frame
Tensioner so that the axle rests in the V-shaped groove in the
Frame Tensioner.
14. Insert the Compression Spring into the opening in the back of the
Frame Tensioner so that the end of the spring fits over the post
inside the opening.
15. Fit the Compression Spring over the post at the back of the Y-Arm
Assembly.
16. Fit the notch in the front end of the Frame Tensioner over the notch
in the front of the Y-Arm Assembly.
17. Depress the back of the Frame Tensioner and slip the Carriage Belt
over the Servo Motor pulley. Make sure that the guides in the
Carriage Belt are properly fitted over the Servo Motor pulley.
18. Gently move the Carriage Assembly from end to end and make sure
that the Carriage Belt is not rubbing against any other parts.

Remove the Carriage PCB

1. Perform the Carriage Assembly, Carriage Belt, and the Frame
Tensioner Removal procedures to remove the Carriage Assembly
from the Slide Shaft.
2. Put on an ESD wrist strap.
3. Unlock the connectors and remove all flex cables on the Carriage
PCB.
5-28 Assembly\Disassembly
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.