Chapter 5 Assembly\Disassembly; Introduction - ENCAD CADJET Service Manual

Assembly\Disassembly

Introduction

Chapter 5 contains the procedures for removal and replacement of the
CadJet 3D printer assemblies and mechanisms. Illustrations are
provided for clarity. Steps for each replaceable part may depend on
parts already removed in previous disassembly directions. It is recom-
mended that you read through each procedure before beginning the
removal and replacement of any assemblies or mechanisms.
The following is a list of tools which are recommended to disassemble
and reassemble the printer:
The following materials are also required:
A Hardware Kit is available for the printers. See Chapter 6 of this
manual for the part number.
•
#1 Phillips Torque Screwdriver
•
#2 Phillips Torque Screwdriver
•
#1 Slotted Torque Screwdriver
•
#2 Slotted Torque Screwdriver
•
#1 Phillips Screwdriver
•
#2 Phillips Screwdriver
•
#1 Slotted Screwdriver
•
#2 Slotted Screwdriver
•
Wrench, 1/4"
•
Screwdriver, Socket Head, 1/4"
•
Wire Cutters
•
Needle Nose Pliers
•
X-ACTO Knife
•
ESD Wrist Strap
•
Isopropyl Alcohol
•
Cotton Swabs
•
Lint Free Cloth or Tissue
•
Double Sided Tape (1/16" thick, 3/4" wide)
•
Loctite Blackmax, P/N 200172
5
5-1