Installing The Camera; Wired Connection To A Network - Beward N 1000 Installation & User Manual

Built-in multi-zone motion detector

Hide thumbs Also See for N 1000:

Table of Contents

 Unshielded twisted pair cables should be located at distance of at least 1.5 meters from

electromagnetic interference sources that produce electric field strength exceeding 3

V/m.

 Switchboards with pinned unshielded twisted pair cables should be located at distance

of at least 3 meters from electromagnetic interference sources that produce electric field

strength exceeding 3 V/m.

 Entire twisted pair cables should be arranged between the points of connection so the

cable run is as short as possible.

 Minimum cable bending radius is four times the cable diameter (or 1 inch=2.5 cm) or it is

also acceptable to install the cable so the cable bending radius is 2 inches (5 cm).

 Maximum length of the entire segment is 100 meters.

4.3. Installing the Camera

Step 1: attach the bracket to the surface using 3 self-tapping screws.

Step 2: loosen the bracket screws to move the camera to the desired position.

Step 3: attach the camera to the bracket, adjust the tilt angle and fasten the camera.

Step 1: provide power to the camera using the included 5 V 1 A power supply.

Step 2: use the supplied RJ45 cable to connect the camera to a network (a LAN port of the

router).

If needed, you can purchase a network cable separately or if you have the materials, tools

and skills, you can make a network cable.

A straight RJ-45 cable (UTP category 5)

The table below shows an example of a patch cord to connect the camera to a computer or

a network switch.

N1000 Installation User Manual

Chapter 4. Installing the Camera and Connecting a Cable

Table of Contents