Beward N 1000 Installation & User Manual page 45

Built-in multi-zone motion detector

Hide thumbs Also See for N 1000:

Table of Contents

To change the ports of the camera, follow these steps:

IMPORTANT!

You can share the same HTTP port between your IP cameras using port forwarding on the virtual server;

however, you must specify a unique RTSP port number for each camera in order to access them over the

Internet.

Step 1: connect to your camera's web interface and go to SETTING – Basic – Camera –

General.

Step 2: in the [RTSP port] field, enter the RTSP port number that is different than the

default port number. For this example, we use the RTSP port 10000 (Pic. 6.4).

Step 3: click [OK] to save the changes.

If there is another camera on the network, you can configure it as follows: HTTP port 80,

RTSP port 10001.

The camera configuration is complete. Now you need to configure your router to make the

camera accessible over the Internet. To do so, follow the steps below:

Step 1: enter the IP address of your router in the browser address field (in the provided

example, the address is 192.168.0.1). In the appeared window, enter your username and your

password. After successful authorization, the router settings page appears (Pic. 6.5).

N1000 Installation User Manual

Chapter 6. Accessing the Camera over the Internet

Pic. 6.4

Table of Contents