Setting Up The Equipment To Work With Dyndns - Beward N 1000 Installation & User Manual

Step 5: if your domain name is activated successfully, you will see the confirmation page
(Pic. 6.24).
Step 6: your domain name is created.

6.4.4. Setting up the Equipment to Work with DynDNS

After the previous steps are completed, you need to set up your camera according to your
registration details at DynDNS service (see
The IP camera and a router (in case if you camera is connected to the Internet through a
router) can both update the IP address at DynDNS server.
To set up your camera to work with DynDNS service, please follow the steps below:
IMPORTANT!
Your camera must be connected to the Internet directly.
Step 1: enable the [DDNS] option at SETTING – Basic – Network – DDNS.
Step 2: select a DDNS provider in the [Server name].
Step 3: enter the username that you chose at registration in the [User ID].
Step 4: enter the password that you chose at registration in the [Password].
Step 5: re-type the password in the [Re-type password].
Step 6: enter the domain name that you chose at registration in the [Host name].
N1000 Installation User Manual
Chapter 6. Accessing the Camera over the Internet
Pic. 6.24
paragraph 6.4.2, 6.4.3).
56