Install The Log Set - Jøtul GF 600 DV II Installation And Operation Instructions Manual

Install the Log Set

The five-piece log set is packaged inside the firebox.
It includes a bag of ember stones that simulate
glowing coals when the burner is operating.
Do not handle the log set with your bare hands.
Always wear gloves to prevent skin irritation from
the ceramic fibers.
1. Install the Logset and Ember Stones as shown in
figures 22-27.
2. Replace the Glass Frame.
Slide the glass frame back down against the front of
the firebox until it is securely seated at the bottom. Pull
the latches forward to engage with the notches in
upper frame rail.
3. Replace the Top Plate and Grille.
Figure 22.
Install Right
Log on pins.
Figure 23.
Install Rear
Log on pins.
#220993
Figure 24.
Install Left Log
on pins.
18
#220994
#220992
#220995
Figure 25.
Left Middle Log rests on pins.
Right Middle Log rests in place.
#220701
Figure 26.
Engage the Top Log with the pin in the
Rear Log and rest the lower end over the
Left Middle Log.
Pilot Assembly
Figure 27.
Loosely spread the
Ember Stones over
the burner plate.
Take care to keep
ember stones off of
the pilot carry-over
ports and away from
the Pilot Assembly.
#221105
Carry-over Ports