Log Set Installation - Jøtul GF 400 DV Sebago Installation And Operation Instructions Manual

Log Set Installation

NOTE: If appropriate, install the optional Antique Brick
Panel Kit before assembling the logset.
The GF 400 DV Sebago logset must be installed before
operating the burner. The logset includes five log pieces,
packaged inside the firebox, and a quantity of ember
stones packaged in the Miscellaneous Parts bag.
To install the log set, remove the packaging and place the
parts inside the firebox as illustrated in figs 32-37. Do
not handle the log set with your bare hands. Always
wear gloves to prevent skin irritation from the ceramic
fibers.
The ember stones realistically simulate glowing coals
when the burner is operating. These should be spread
evenly over the burner plate and around the logs. DO NOT
OBSTRUCT THE PILOT ASSEMBLY OPENING. See fig. 37.
NOTE: You do not need to use all the ember stones.
With experimentation, you will find the arrangement
and quantity of embers that works best with your stove.
Depending upon the characteristics of your installation,
it is possible that too many ember stones can promote
sooting on the logs. Adjust the quantity of ember stones
as appropriate to maintain the best overall flame
picture.
THE CERAMIC FIBER LOGS AND GLOWING EMBERS CAN
IRRITATE YOUR SKIN. GENTLY WASH YOUR HANDS WITH
WARM SOAPY WATER AFTER HANDLING THE LOGS.
Figure 32. Install Right Log
Figure 33. Install Rear Log
Figure 34. Install Left Log
Figure 35. Install Middle Log
Figure 36. Install Crossover Log
Figure 37. Install Ember Stones
Pilot
Opening
DO NOT
OBSTRUCT
21