Operation - Jøtul GF 600 DV II Installation And Operation Instructions Manual

Operation

Familiarize yourself with the controls of the GF 600
DV II Firelight. Make sure that anyone else using the
appliance is also familiar with the controls and
operation procedures. Always follow the Lighting
Instructions on the inside back cover of this manual
and also located on the Rating Plate attached to the
burner assembly.
1. Once the pilot is lit, burner operation is controlled
by the rocker switch located at the left rear
corner of the stove. See fig. 36. Use the T-STAT
position for the optional thermostat or remote
control functions.
2. During the first few fires, you may notice odor
and/or smoke from the stove. This is normal and
results from burn-off of manufacturing residue
and curing of materials. You may find it helpful to
provide additional ventilation and fresh air to
alleviate this condition.
3. Condensation may develop on the glass when the
burner is first lit. This "fog" will disappear as the
heater warms up.
4. Keep the controls and the area under the appli-
ance free of debris, vacuum this area frequently.
Always keep the appliance area clear and free
from combustible materials, gasoline and other
flammable liquids. The flow of combustion and
ventilation air must not be obstructed.
If a vacuum is used during any service on the
stove, ALWAYS be sure the stove is cold.
5. This appliance has a continuous burning pilot
flame. Exercise caution when using products
having combustible vapors. Always shut-off gas
supply while servicing the stove.
6. CAUTION: DO NOT OPERATE THIS APPLIANCE
WITH THE GLASS REMOVED CRACKED OR BRO-
KEN. Replacement of the glass should be done by
a licensed or qualified service person. Use only
replacement glass provided by your authorized
Jøtul dealer. Never use any substitute materials.
WARNING: OBSERVE CAUTION WITH THE GLASS.
THE GLASS PANEL MAY SHATTER UNEXPECTEDLY
IF STRUCK WITH AN OBJECT. ALWAYS HANDLE
THE GLASS PANEL WITH CARE. WHEN SERVICING
THE STOVE ALWAYS PULL THE GLASS ASSEMBLY
STRAIGHT UP FOR REMOVAL.
Figure 36. Burner Control Switch Location
7. Clean the glass only when necessary. Wipe
surface with a clean, damp soft cloth. Follow with
a dry, soft towel as desired. Take care not to
scratch the glass surface.
WARNING: DO NOT USE ABRASIVE CLEANERS ON THE
GLASS. NEVER CLEAN THE GLASS WHEN IT IS HOT.
23