Jøtul GF 600 DV II Installation And Operation Instructions Manual page 15

5. Remove the wingnut and fender washer from the
Air Shutter stem, located under the stove, directly
behind the valve. See fig. 17.
6. Pull the Burner Plate forward to disengage it and
the Air Shutter from the burner orifice and lift it
out of the firebox.
7. Change the main burner orifice. Using a ½"
open end wrench or deep-well socket, remove
the burner orifice from the brass orifice holder.
Replace with the orifice supplied in the kit.
Tighten securely.
8. Change the Pilot Orifice. From within the
firebox, pull the pilot hood off the pilot assem-
bly. See Fig. 18. Using the 4 mm allen wrench
included with the conversion kit, remove the
original pilot orifice (counterclockwise).
Replace with the appropriate orifice:
#51 for natural gas
#30 for propane
9. Tighten orifice into the base of the pilot assem-
bly. Be sure the orifice is tightly secured to
prevent bypass leakage. Replace pilot hood onto
the pilot assembly.
10. Replace the Air Shutter over the burner orifice.
Note that NG/LP designations are stamped on the
sides of the shutter. Orient the shutter so that the
appropriate fuel designation is on the right, facing
the pilot assembly. See fig. 17a.
11. Reinstall the Burner Plate by engaging the tube
with the Air Shutter.
12. Replace the fender washer and wingnut on the
Air Shutter stem under the firebox. Secure
loosely for adjustment later.
13. Replace the Rear Wall Skirt and Burner Skirt.
14. Replace the variable regulator. Using a Torx T-20
screwdriver, remove the three specialty screws
from the HI/LO regulator on the front of the
valve. Note: To help identify which screws to
remove, refer to the new regulator in the kit. See
Figure 19.
15. Remove the regulator tower and the gasket. Be
sure to remove the black rubber gasket from the
valve.
16. Install the new variable regulator tower from
the kit. Be sure that the gasket is properly
positioned and tighten screws securely.
17. Install the identification labels to the stove so
that they can be seen by any person that may be
servicing the stove.
Label A: Apply to back of stove.
Label B: Apply to the Rating Plate.
Small valve sticker: Apply to valve.
NEVER USE AN OPEN FLAME TO CHECK
FOR GAS LEAKS.
It is important that the correct gas pressure be
established at the time of installation. For more
details see the Gas Pressure section of this manual
(page 13).
ALWAYS REFER TO THE LIGHTING
INSTRUCTIONS ON THE INSIDE BACK
COVER OF THIS MANUAL WHEN LIGHTING
THE STOVE.
Burner
Orifice
Figure 16a. Burner orifice and pilot assembly
locations.
OPEN
Open
Figure 17. Remove the Air Shutter wingnut and fender
washer.
Figure 17a.
Replace the Air Shutter.
Pilot Head
Pilot Orifice
Figure 18.
Remove pilot head
and pilot orifice.
Pilot
Assembly
CLOSE
Close
Air Shutter
Wingnut
NOTICE: Appropriate fuel
identification should be on
right side
15