Optional Blower Kit - Jøtul GF 600 DV II Installation And Operation Instructions Manual

Optional Blower Kit 156000

Installation
DO NOT CONNECT BLOWER TO POWER
SOURCE UNTIL ALL WIRE CONNECTIONS
HAVE BEEN MADE.
CONNECT THE GAS SUPPLY TO THE STOVE
BEFORE INSTALLING THIS BLOWER. USE A 90°
ELBOW OFF THE GAS VALVE TO CREATE
ADEQUATE GAS LINE CLEARANCE.
This blower must be electrically grounded
in accordance with local codes or, in the
absence of local codes, with the current
ANSI/NFPA 70, National Electrical Code or
CSA C22.1-Canadian Electrical Code.
This unit is supplied with a three-prong
(grounding) plug for protection against
shock hazard and should be plugged
directly into a properly grounded three-
prong receptacle. DO NOT CUT OR REMOVE
THE GROUNDING PRONG FROM THE PLUG.
Always disconnect the power supply when
performing any service.
CAUTION: Label all wires prior to disconnec-
tion when servicing controls. Wiring errors
can cause improper and dangerous opera-
tion. Verify operation after servicing.
ATTENTION: Au monent de l'entretien des
commandes, etiquetex tous les fils avant le
debranchement. Des erreur de ceblage
peuvent entra tun fonctionnnemnet
inadequat et danereux.
Installation Procedure
1. Unpack and check the contents of the blower
kit. Contact your dealer if any damage is evident
or parts are missing. See fig. 1.
2. Attach the Snapstat Bracket to the studs located
in the middle of the firebox floor using the two
M6 hex nuts and a 10 mm wrench. See fig. 2.
3. Attach the Blower Bracket to the stove using the
two M6 flange head hex bolts as shown in fig. 2.
SHORT LEG NOTE: If using short legs, follow Step
4 to attach the blower to the bracket BEFORE
attaching the bracket to the stove.
10
11
3
1
Contents
1. Blower
2. Mounting Bracket
3. Snapstat Wire Harness
4. Control Switch Wire Harness
5. Snapstat
6. Snapstat Bracket
7. M6 Flange Nuts (2)
8. M6 X 12 Hex Head Flange Bolts (2)
9. M6 x 12 Wingscrew (1)
10. #8 x 1/2" sheet metal screws (4)
11. Duct Deflector (2)
Figure 31. Kit Contents - 156000 Blower
M6 x 12
Hex Head
BACK OF STOVE
Flange Bolts
Blower Bracket
Figure 32. Attach Snapstat and Blower Brackets.
6
5
7
8
4
9
Tools Required
• 10 mm wrench
• short phillips
screwdriver
• Safety goggles
• Work gloves
Snapstat
Bracket
M6 x 12 Hex Head
Flange Nuts
2
21