Jøtul GF 600 DV II Installation And Operation Instructions Manual page 22

Blower Motor
Housing
Ducts oriented to rear
Figure 33. Blower orientation.
4. Install the Blower: Orient the duct openings up and
to the back as in fig. 33. Route the snapstat wire
harness over the blower motor housing. Remove
the wire ties from the controls wire harness and
route it under the blower to the side. Secure the
blower to the bracket with the wingscrew.
5. Attach either Snapstat wire connector to either
Snapstat terminal. See fig. 33
6. Install the Snapstat by sliding it all the way into the
slot in the bottom of the Snapstat Bracket as
shown in figs. 31 and 33.
7. Connect the male wire harness connector to the
female wire harness already installed in the stove.
See fig. 33.
8. Connect power cord to outlet only after all wire
connections have been made.
Blower Operation
The optional variable-speed blower will enhance
heat circulation around the firebox and out into the
room. Controls are located at the left side of the rear
shroud of the stove, fig.34. The blower is controlled
by a heat activated switch (snapstat) that will ONLY
function when the control switch is in AUTO setting.
After the fire has been burning for a time, the
snapstat will react to the heat and activate the
blower. Fan speed may be manually adjusted with
the rheostat knob. If the burner turns off, the blower
will be shut off automatically when the stove cools
down.
If automatic blower circulation is not desired,
place the blower control switch in the MANUAL
position.
22
Snapstat
Connectors
Wingscrew
Choose Automatic or
Manual Modes
Figure 34. Blower Controls
G
W
G
BL
BK
POWER
GY
SUPPLY
P P
BL
GY
MANUAL OFF AUTO
Figure 35. Blower Wiring Diagram
Male
QuickConnector
Female
QuickConnector
Speed Control
BLOWER
W BK
BK BK
P
BK BK BK
P
RHEOSTAT
SNAPSTAT
BR
P
P = QuickConnector Pin
BR
SWITCH