Maintenance - Jøtul GF 600 DV II Installation And Operation Instructions Manual

Firelight direct vent gas heater
Table of Contents

Advertisement

Maintenance

The GF 600 DV II Firelight gas stove and its venting
system should be inspected before use and at least
annually by a qualified service technician.
IMPORTANT:
ALWAYS TURN OFF THE GAS SUPPLY TO
THE STOVE BEFORE ANY SERVICE WORK
IS PERFORMED ON THE STOVE.
General cleaning: The firebox should be vacuumed
annually to remove any surface build up. Be sure to
vacuum or wipe off the pilot assembly and burner
orifice and burner plate. Also, when vacuuming the
log set, be sure to handle each piece carefully as
they are very fragile.
Gasket inspection: It is important that the glass
gasket be inspected at least annually. Examine the
rope gasket for signs of deterioration and make
sure the gasket has a positive seal. This is impor-
tant to prevent combustion gases from escaping
into the room. Replace the gasket if it is frayed, stiff
or brittle. Refer to the replacement parts list on
page 26.
Always replace any damaged or broken parts on
the GF 600 DV II Firelight with JØTUL AUTHORIZED
PARTS ONLY. These are available through your Jøtul
dealer. Never use any substitute parts on your GF
600 DV II Firelight gas stove.
Glass Replacement
Use only Jøtul PN 129124 Tadpole Gasket and PN
12102633 Glass Panel for this appliance.
1. Release the spring clips at the top of the firebox
and slide the glass frame up and out of the
firebox.
2. Use a flat blade screwdriver to bend the two side
retainer tabs up to release the original glass
panel and remove it from the frame.
3. Beginning at the center of one of the long sides,
wrap the new tadpole gasket material around
the new glass pane, pressing the adhesive firmly
against the glass surface. See fig. 37.
4. Place the glass panel within the frame oriented
with the gasket seam at the bottom and the
thinner side of the gasket against the frame.
Carefully bend the retainer tabs back only
enough to secure the glass panel. See fig.37a.
5. Replace the glass frame into the firebox.
24
Figure 37.
Replacing the Glass Gasket.
Retainer Tab
Figure 37a.
Replacing the glass panel into the frame.
FOR YOUR RECORDS
Record the following information to help
your dealer determine what you will need
should you ever require parts and service.
GF 600 DV II Firelight
MODEL NAME:
SERIAL NUMBER:
DATE OF PURCHASE:
PURCHASED FROM:
NAME OF INSTALLER:
TYPE OF FUEL:
FUEL CONVERSION:
BY:
RETAIN THIS MANUAL FOR
REFERENCE AND MAKE IT
AVAILABLE TO ANYONE USING
OR SERVICING THE STOVE.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents