Log Set Installation - Jøtul GF300 DV IPI Allagash Installation And Operation Instructions Manual

Log Set Installation

Brick Kit Note: Install the optional Reversable Panel Kit
157458 before installing the log set. See page 20 or the
instructions provided with that kit.
The GF 300 DV IPI log set must be installed before
operating the burner. The log set includes six log pieces,
packaged inside the firebox. A quantity of ember stones
is with the log set. Place the parts inside the firebox as
illustrated in figs. 35-39.
WEAR GLOVES AND HANDLE THE LOG PARTS CAREFULLY.
#157445 Log Set Identification
#1 Rear
#2 Left Front
#3 Right Front
#4 Right Cross
#5 Middle Cross
#6 Left Cross
IMPORTANT
The ember stones realistically simulate
glowing coals when the burner is operating.
These should be spread evenly over the burner
plate and around the logs.
TO INSURE PROPER BURNER FUNCTION,
DO NOT OBSTRUCT THE PILOT ASSEMBLY AND
BURNER SKIRT OPENINGS WITH EMBER STONES.
KEEP EMBERS AWAY FROM THE PILOT CARRY-
OVER PORTS.
You do not need to use all of the ember
stones. With some experimentation, you will
find the arrangement and quantity of embers
that works best with your stove. Depending
upon the characteristics of your installation,
it is possible that too many ember stones
can promote sooting on the logs. Adjust the
quantity of ember stones as appropriate to
maintain the best overall flame picture and
burner performance.
224962
224963
224964
224965
224966
224967
Figure 35. Locate the Rear Log over the two pins on the
back shelf of the burner skirt.
2
Figure 36. Place the Left and Right Front Logs on the pins in
the center of the burner plate.
Figure 37 Position the Right Cross Log across the Rear Log
and Right Front Logs.
139495_Rev_C GF 300 DV IPI 9/11/12
1
3
4
21