Table of Contents
Advertisement
Caution! Do not fit the batteries into the
remote control receiver until the wires are
connected to the burner control unit, as a
short circuit could result in the destruction
of the electrical components.
• Connect the wiring harness to the receiver box, by
pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so, please
ensure that the wires are pointing up and slot in the
board is in line with the tab on the wiring harness
plug.
• Connect wires as shown below.
Please note that the "L" connectors are different
sizes, the smaller one fits to the lower connection
on the valve.
• Remove the remote control receiver lid.
• Fit four 1.5V alkaline batteries.
• Place the remote control receiver on the Velcro pad.
• Fit the 9V alkaline battery to the handset
transmitter.
12
12
Remote Control Installation
- Quick Links:
- Replacement Parts
Hide quick links:
Advertisement
Table of Contents
