Remote Control Handset Wall Holder Installation; Owner's Information - Valor 650ILN Installation & Operating Instructions Manual

Remote Control Handset Wall Holder Installation

The remote control kit for this fi replace comes
complete with a wall-mounted holder. This
holder is not required in all installations but
is provided as an optional feature for those
customers who wish to mount the remote
handset to the wall.
To install the holder to the wall, fi nd a
convenient location and use the hardware
provided with the kit. See the diagram on the
right for required hardware and confi gurations.
Note that the holder can be installed at the base
of a light switch plate.
IMPORTANT. The location of the remote control
handset is important to assure proper temperature regulation. To obtain a constant temperature, we recommend that
the handset should be between 3 and 15 feet away from the appliance but not directly above it. We also advise
that the handset should be located away from any other heat source and not in direct sunlight as this may affect the
temperature sensor located in the remote handset.
CAUTION
Your fi replace becomes very hot when operating. Your fi replace becomes very hot when operating.
Avoid placing decorating objects sensitive to heat Avoid placing decorating objects sensitive to heat
within 36 inches (0.9 m) around it. within 36 inches (0.9 m) around it.
Performance of LPG appliances may be affected by
the quality of commercial gas supplied in your area.
You'll fi nd
your Warranty
Card at the
back of this manual.
Read the Safety
Information
section on page
4 of this manual.
Operating Your
Fireplace
For your safety, this appliance is fi tted with a fl ame
supervision device which will shut-off the gas supply
if, for any reason, the pilot fl ame goes out. This device
incorporates a fi xed probe, which senses the heat
from the pilot fl ame. If the probe is cool, the device will
prevent any gas fl ow unless manually lighting the pilot.
See full lighting instructions on page 34 of this manual.
28 28

Owner's Information

Fireplace
Hearth
Do not put
furniture or other objects
in this space in front of
the fireplace:
36" (0.9 m)
Packing Contents:
1 Wall Bracket A
2 Screws B
1 Screw C
2 Wall Anchor D
1 Spacer E
(detach before assembly)
1 Wall Bracket F
Alternative 1
Cleaning
DO NOT TOUCH THE GLASS WHILE IT IS HOT! DO NOT TOUCH THE GLASS WHILE IT IS HOT!
Let the fi replace cool fi rst before cleaning it. Let the fi replace cool fi rst before cleaning it.
Important - Glass cleaning - Mineral deposits
One of the by-products of the combustion process in a
gas appliance is a mineral which can show up as a white
fi lm on the ceramic glass of the window.
The composition of the deposit varies widely from various
locations and also from time to time in the same location. It
seems this is associated with the varying sulfur content of
the gas. You may have the problem for a time and then not
see it for many months when it will reappear in your area.
We have discussed this problem with ceramic glass
manufacturers and they cannot give us a defi nitive
answer to this problem. Dealers have tried various
cleaning products with varying results. The following
recommendations does not guarantee results in your
particular case.
NOTE: This is a problem beyond Miles
Industries' control and is not covered under
warranty.
• Clean the glass regularly as soon as you notice the
buildup (white fi lm). If the fi lm is left for a longer period
of time, it will bake on. It is then much harder, if not
impossible, to remove.
NEVER use an abrasive cleaner on the ceramic
•
glass. Any abrasion of the surface has the immediate
effect of compromising the strength of the glass. An
emulsion type cleaner is recommended.
Alternative 2
Alternative 3
WARNING
Switch Plate