Remote Control Initial Set-Up; Operation Check & Aeration Settings Adjustment - Valor 650ILN Installation & Operating Instructions Manual

H4 series direct vent gas fireplace heater

Hide thumbs

Table Of Contents

Table of Contents

The receiver and the handset of the remote control

system must be initially synchronized before the ﬁ rst use.

1. Insert alkaline batteries in the remote control

receiver and handset. The receiver is located left of

the control valve under the burner module.

2. With a sharp object, press and hold the receiver's

reset button until you hear one short and one long

beeps. Release the reset button after the second

beep.

3. Within the subsequent 20 seconds, press the small

ﬂ ame button (

) on the remote handset until you

hear two short beeps conﬁ rming the sychronization

is set.

This is a one time setting only and is not required when

changing the batteries in the remote receiver. The

remote control system is now ready to use.

Operation Check & Aeration Settings Adjustment

Operation Check

Turn the ﬁ replace ﬂ ame up and down using the

remote control to conﬁ rm that the full range of inputs

is achieved—see the remote control operation

instructions on pages 31–34.

Aeration Settings

Light the ﬁ re and allow the unit to warm up for 10–15

minutes to evaluate the ﬂ ame picture. Burners are

equipped with an adjustable shutter to control primary

aeration. See the ﬁ gures below. The shutter is

factory-set to an aeration gap which will give optimum

performance for the vast majority of installations.

Air Shutter

NG Air Shutter

Slider & Cover