Framing - Valor 650ILN Installation & Operating Instructions Manual

• A non-combustible hearth is not necessary in front of this appliance.
• Note that the unit is installed at the framing stage and fi xed to framing using support angles. See page 20. The
wall fi nish is then installed over the support angles up to the front frame on the unit, on the sides and up to the
stand-offs on the top.
When the appliance is installed directly on carpeting, tile or other combustible material other than wood fl ooring, the
appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance.
30-3/4" (768 mm)
Combustible framing
allowed beneath fireplace.
When the appliance is
installed directly on
carpeting, tile or other
combustible material
other than wood
flooring, the appliance
shall be installed on a
metal or wood panel
extending the
full width and recessed
depth of the appliance
FRAMING DIMENSIONS
FRAMING IN A CORNER
10 10
Wall Finish
to wall finish
16" (406 mm) min. straight out
or off the top venting.
Allow for elbow if rear vent with rise.

Framing

38-3/4" (984 mm) to underside of
header and cavity height
46" (1168 mm) min.
MINIMUM 1/2" (13 mm) space
between bottom of backing
plate and surface of hearth or
floor finish in front for air flow