Wall Switch Kit Installation - Valor 650ILN Installation & Operating Instructions Manual

CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires are
connected to the burner control unit as short-
circuit could result in the destruction of the
electrical components.
The wall switch kit is connected to the receiver in the
fi replace. The receiver is located left of the control
valve under the burner module.
1. Decide where the switch is to be installed. Install an
electrical outlet box (not supplied).
2. Thread the switch wire through an access hole in
the appliance.
CAUTION
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
3. Pull out the receiver box. Remove the batteries
from the receiver box if it contains any. You can
remove the ignition wire to improve access to the
receiver.
Wall Switch Harness
Valve Wire Harness
Ignition Wire Connection
(spade type connector)
Be careful when removing and
reinstallaing: not to bend or break
the spade connector
26 26

Wall Switch Kit Installation

4. Take the switch wire and plug it into the receiver's
5. On the outside of the fi replace, run the switch wire
6. Plug the wire into the switch plate and to the outlet
7. Reconnect the ignition wire to the receiver if it was
8. Insert 4 AA alkaline batteries in the receiver.
9. Test the operation of the wall switch.
10. Fix the wall cover plate to the outlet box.
11. Replace the receiver in its position and as well as
Ignition Wire
Antenna
connection slot as indicated (the other slot should
already be fi tted with the valve's wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
into the outlet box.
box.
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver's antenna.
Replace the cover.
the antenna if deployed.
IMPORTANT: The antenna MUST NOT TOUCH
the ignition wire.
DO NOT USE a screwdriver or
other metallic object to remove
the batteries from the receiver or
the handset! This could cause a
short circuit to the receiver.
To avoid short-circuit to the
receiver, position the antenna so
that it DOES NOT TOUCH the
ignition wire.
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
CAUTION
CAUTION