Command Line Mode - Planet WGSW-28040 User Manual

The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command
modes are described below. Each of the command modes supports specific software commands.
Mode-based Command Hierarchy
The Command Line Interface (CLI) groups all the commands in appropriate modes by the nature of the commands. Examples
of the CLI command modes are described below. Each of the command modes supports specific switch's commands.
The CLI Command Modes table captures the command modes, the prompts visible in that mode and the exit method from that
mode.
Command Mode
User Mode
Privileged Mode
Global Config Mode
The CLI is divided into various modes. The commands in one mode are not available until the operator switches to that
particular mode. The commands available to the operator at any point in time depend upon the mode. Entering a question mark
(?) at the CLI prompt, and displayss a list of the available commands and descriptions of the commands.
The CLI provides the following modes:
User Mode
When the operator logs into the CLI, the User Mode is the initial mode. The User Mode contains a limited set of commands. The
command prompt shown at this level is:
Command Prompt: WGSW-28040>
Privileged Mode
To have access to the full suite of commands, the operator must enter the Privileged Mode. The Privileged Mode requires
password authentication. From Privileged Mode, the operator can issue any Exec command to enter the Global Configuration
mode. The command prompt shown at this level is:
Command Prompt: WGSW-28040#
Access Method
This is the first level of access.
Perform basic tasks and list
system information.
From the User Mode, enter the
enable command.
From the Privileged Mode,
enter the configuration
command.
Table 6-1 CLI Command Modes
User's Manual of WGSW-28040 / 28040P / 28040P4

6. Command Line Mode

Prompt
WGSW-28040>
WGSW-28040#
WGSW-28040 (Config)#
222
Exit or Access Previous
Mode
Enter Logout command
To exit to the User Mode, enter
exit or Logout.
To exit to the Privileged Mode,
enter the exit command.