Mitsubishi Electric Freqrol Z024-UL Instruction Manual page 74

Note: Setting should be made with voltage across the frequency reference input terminals 2
and 5 using 5
V (or 10 V) or with input lines disconnected. (When setting characteristics
shown in the illustration on the previous page.)
If a voltage is being applied, output frequency relative to that voltage is set. In the above
procedure, for example, if 1 V is being applied across terminals 2 and 5, output
characteristics become as shown in the illustration below (solid line).
10
Hz
If
you want to set 0 Hz against
1 V
/ ? -
,
input, set 0 Hz in the above procedure.
. A
I
0 1'v
5'v
-68-