Operatlng Procedure
1. Operate PU to set the
frequency for meter full-
scale reading.
(*)
2. Select the meter calibration
mode.
3. Calibrate the meter.
(Set to 60 Hz when the
inverter is shipped.)
of the frequency meter,
When the meter has been calibrated, press the
WRI
key.
'The motor need not be connected.
Note: If a signal relative to magnitude of motor current is to be output from the FM terminal (see page
95),
install a calibration resistor at the position shown on the previous page. Output of the FM
terminal is not adjusted with the above procedure.
-65-