Power Installation; Initial Setup - Bell Excursion 36248 Instructions Manual

POWER INSTALLATION

BASE UNIT POWER CONNECTION
CAUTION:
You must use a Class 2 Power Source 9VAC 500 mA. The plug must
correctly fit the unit's adapter jack.
1. Plug the adapter into a standard AC outlet.
2. Insert the small plug into the adapter jack on the rear of the base as shown in Figure 9.
HANDSET BATTERY INSTALLATION
CAUTION:
Use only the Nickel Cadmium (Ni-Cd) battery type included with this unit.
Use of other battery types may cause injuries or damage.
Remove the battery compartment cover of the handset. Connect the rechargeable
1.
Ni-Cd battery as shown on Figure 10.
Insert the Ni-Cd battery into the battery compartment of the handset.
2.
Slide the battery compartment cover firmly in its closed position.
3.

INITIAL SETUP

Before you can use your cordless telephone, the handset must be charged for at least 20
hours. See charging instruction on MAXIMIZING BATTERY LIFE section of this manual.
SETTING THE DAY AND TIME OF THE BASE UNIT
NOTE: The time set is used for time stamping the recorded message(s).
1.
After 20 hours, lift the handset from the base unit.
2.
Press the REMO button on the handset. The Excursion
no new message. For help, press 9." followed by a long beep.
(Figure 9)
(Figure 10)
®
36248 will prompt "You have