Power Connection - Bell Excursion 39280 Owner's Manual

inner slots of the base unit as shown
in Figure 4.
5. Press the middle locking hooks of
the mounting bracket while pushing
the back of the mounting bracket
until it snaps to lock as shown in
Figure 5
NOTE: Ensure that the lock guide
stays in place on the hole provided
on the base unit as shown in Figure
6.
Plug the free end of the short line
6.
cord into the modular wall jack.
Align the upper keyhole on the
7.
mounting bracket with the upper
stud of the wall plate, so that the
opeing end of the mounting braket
matches the lower stud, pull the
mounting bracket down until it is
securely seated.
Wall Mount Bracket
(Figure 7)
Wall Mounting (No Standard Wall Jack)
1. Drill two holes with a vertical
distance between the two marked
"
15/16 ( 100mm) as
positions of 3
shown in Figure 8.
(Figure 8)
2. Drive a screw into each of the holes.
Tighten them to the end of the screw
9
OWNER' S MANUAL # 39280 ver. 061703A-1
Page: 9
3.
4.
Uninstalling the Wall Mount Bracket
Wall
Mount
To remove the wall mount bracket form
Stud
the base unit, pull it back as shown in
Figure 10.
Telephone
Modular
Jack
Wall
Mount
Stud

POWER CONNECTION

ENGLISH VERSION
lines, only leaving the smooth part
of the screw head outside the wall.
Install the wall mount bracket into
the base unit as previously discussed
in Figures 3-6.
Hand the unit onto the screws, then
slide it down firmly to fasten the
base securely, as shown if Figure 9.
Wall Mount Bracket
(Figure 9)
(Figure 10)
061703A-2
Wall
Mount
Stud