Tone/Pulse Switch; Handset Volume; Battery Installation; Battery Duration - Bell Sonecor BE-3850 Installation And Operating Manual

TELEPHONE SETUP

Tone/Pulse Switch

Tone/Pulse
Switch
Tip: If you are unsure of the proper dialing mode, make a trial call with the dial
mode setting to TONE. If the call connects, leave the switch as is (TONE
mode), otherwise, set to PULSE.
NOTE: Pulse dialing works for direct dialing and redialing only, not for memory
dialing.

Handset Volume

Adjust the receiver volume of the handset using
the volume control switch on the right side of
the handset.
Note: Ringer options can be selected on the
handset when programming setup
functions (see page 22).
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or Pulse by
setting the switch on the bottom of the
base unit.
Note: Changes to the switch position
during a call do not take effect until
the call has ended.
Volume Control
Switch
15

BATTERY INSTALLATION

To install the cordless Ni-MH handset battery pack:
1. Slide the battery pack up into the compartment at the
bottom of the handset. Make sure that the end of the
battery with the contacts is inserted first.
2. Snap the battery compartment cover into place.
3. Place the handset on the charging cradle.
4. Once you have installed the battery pack and placed
the handset on the cradle you will hear a tone
indicating the handset has connected with the charging
contacts and will successfully charge.
5. IMPORTANT: Charge the battery pack for at least 12
hours before using the handset the first time.
6. The IN USE/CHARGE LED on the charging cradle will
light when the handset is properly making contact with
the charge terminals.

Battery Duration

A fully charged battery lasts for approximately:
• 4 hours when you use the handset continuously (talk
time).
• 5 days when the handset is not in use (standby).

When the Battery Needs Charging

• The phone will beep.
• The display will show the Low Battery icon.

When to Purchase a New Battery Pack

If the battery lasts only a few minutes even after a full charge, the usable life of the
battery has expired and needs to be replaced. For replacement batteries
visit http://www.bell-equipment.com/support or
you can contact Aastra Telecom customer support center
at 1-888-663-1505 for information about how to order a new battery.
16