Mounting Position - Bell Excursion 36248 Instructions Manual

and Two-Way Recordings. Blinks if there are new Incoming Message(s) (ICM) or
Two-Way Recording(s).
18.
CHG (Charge) / IN USE LED Indicator: Lights up steadily when the phone is being
used and when the handset is being charged on the base .
19.
Digital LED Display: A two-digit LED display to indicate the number of Incoming
Message(s) and Two-Way Recording(s). Also displays the system status and the
current channel number while in TALK mode.
Code
00-59
--
Ir
2r
An
rc
FU
ER
OP
Or
20. Retainer Tab: Allows the handset to hang on the base unit at wall mount position.

MOUNTING POSITION

DESKTOP USE:
Connect the telephone line cord to the TEL LINE jack
on the rear of the base unit and connect the opposite
end to the telephone modular jack.
WALL USE :
A. WITH A STANDARD AT&T OR GTE MODULAR WALL JACK
1.
Install the wall mount bracket at the position as shown in Figure 5.
2.
Connect the short telephone line cord to the TEL Line jack on rear of the base.
3.
Connect the opposite end of the telephone line cord to the modular wall jack.
4.
Align the wall mounting slots with the studs located on the modular wall plate and slide
the base down to lock in place.
NOTE: If you do not have a standard modular wall jack, find a qualified technician to mount
one on the wall.
B. WALL MOUNTING (No Standard Wall Jack)
Function
Message / Timer count / Channel No.
Answering OFF
Memo Recording
Two-Way Recording
Answering Mode
Remote Control
Memory Full
Erasing Message
OGM Playback
OGM Recording
( Figure 4)
(Figure 5)