Belt Clip Instruction; Connecting The Headset - Bell Excursion 36248 Instructions Manual

1. Drill two holes with a vertical distance between the two marked positions of 3
mm) as shown in Figure 6.
2.
Drive a screw into each of the holes. Tighten them to the end of the screw line, only
leaving the smooth part of the screw head outside the wall.
3.
Hang the unit onto the screws, then slide it down firmly to fasten the base securely.

BELT CLIP INSTRUCTION

Clamp the belt clip at the back of the handset as shown in Figure 7.

CONNECTING THE HEADSET

For hands free conversation, a headset (not included) is connected to the headset jack as
shown in Figure 8. The handset receiver and microphone are disabled when the headset is
connected.
Press the TALK button to answer or place a call using the headset. Refer to the
manufacturer's headset manual for more details.
(Figure 6)
(Figure 8)
" (100
15/16