Erasing Messages; Memory Full Detection; Call Screening - Bell Excursion 36248 Instructions Manual

ERASING MESSAGES

A.
SELECTIVE ERASING
1.
Press the ERASE button on the base unit during message playback.
®
2.
The Excursion 36248 will announce "(Message) (Memo) (number) erased." and then
start the next message.
NOTE: Erased messages cannot be retrieved. There is a momentary delay after erasing
messages to allow the
®
Excursion 36248 to reorganize and optimize its memory space.
B.
ERASING ALL ICM AND TWO-WAY RECORDINGS
1.
In standby mode, press and hold the ERASE button for about 2 seconds.
®
2.
The Excursion 36248 will announce "Message (number) erased. You have no
message."
C.
ERASING ALL MEMO MESSAGES
1.
In standby mode, press the ERASE button briefly for less than 2 seconds and press
and hold MEMO button for about 2 seconds.
®
2.
The Excursion 36248 will announce"Message erased. You have no Memomessage".
D. ERASING OGM
1.
During OGM playback, press ERASE button.
®
2.
The Excursion 36248 will announce "Erase your announcement. You have no
announcement."
NOTE: After erasing messages during memory full or near memory full, you may hear a
continuous beep for several seconds indicating memory sorting of the unit.

MEMORY FULL DETECTION

The memory full condition occurs:
•
If 15 minutes of recording time is reached, or
•
If 59 messages (i.e. Memo, OGM, ICM) have been recorded.
In this case, the ANS. ON/OFF LED indicator will blink in answer on mode. If there is an
incoming call, the unit will answer at the 10
erase any or all the messages remotely after listening to them. Refer to the REMOTE
OPERATION section for more details.
NOTE: Sometimes you may fail to escape from memory full condition when erasing a short
message. In this case, you must erase more messages (at least 1 minute message).

CALL SCREENING

You can listen to the caller leave their ICM and decide if you want to answer the call.
A.
FROM THE HANDSET (Away From the Base Unit)
®
1. When the Excursion
®
Excursion 36248 will immediately answer the call. You will hear your OGM followed
by the caller's message through the handset receiver.
2.
If you decide to take the call, simply press the TALK button and begin speaking.
B.
FROM THE HANDSET (In the Base Unit Cradle)
®
1.
When the Excursion
caller's message through the base unit's speaker.
2.
If you decide to take the call, simply pick up the handset. Begin speaking and the ICM
recording is stopped. The recorded message is stored in memory and the message
count is incremented by one.
C. FROM THE EXTENSION PHONE
®
1.
When the Excursion
caller's message through the speaker.
2.
If you decide to take the call, just lift the handset of the extension phone on the same
line as the Excursion
and the recorded message is stored in memory while the message count is
incremented by one.
th
ring and announce "Memory full". You can
36248 rings, press the REMO button on the handset. The
36248 answers a call, you will hear your OGM followed by the
36248 answers a call, you will hear your OGM followed by the
®
36248 and press * button twice. The ICM recording is stopped