Installation; Battery Installation - Bell BE-70PS Owner’s Owner's Manual

INSTALLATION

Battery Installation

For Caller-ID operation, the BE-70PS requires one rectangular 9 volt battery
(not included). To install or change the battery, follow these steps.
WARNING: ALWAYS DISCONNECT THE TELEPHONE LINE FROM THE WALL OUTLET
BEFORE SERVICING OR DISASSEMBLING THIS EQUIPMENT OR REPLACING BAT-
TERIES.
1. Use a small Philips head screw driver to remove the battery cover safety
locking screw.
2. Open the battery compartment by placing the edge of your fingernail under
the battery door latch and lifting upwards. See Figure 5
3. Lift the battery door up and remove from the unit.
4. If you are replacing a discharged battery, install a fresh battery within 15
seconds. Taking more time to replace the old battery can result in the loss
of call information that is stored in memory.
5. Install a new 9 volt battery, taking care to observe proper battery polarity.
Figure 5
6. The NEW call LED and all the segments of the display will light for approxi-
mately two seconds followed by the firmware version.
7. Next, "SET LANGUAGE" will appear in the display.
8. Proceed immediately to set the correct display language as required. If you
hesitate more than 30 seconds or skip the following procedure, the display
will go to the stand by screen.
Battery Compartment View
9 VOLT BATTERY
- 10 -
10