Powering On The Switch - HP A10500 Series Installation Manual

On the Settings tab, set the emulation to VT100 and click OK.
6.
Figure 30 Setting terminal emulation in Switch Properties dialog box

Powering on the switch

Before powering on the switch, confirm the following:
You know where the emergency power-off switch for the equipment room is located.
•
The switch has been securely mounted.
•
All the cards have been correctly installed.
•
The unused slots have been installed with blank filler panels.
•
All the network cables, fibers, power cables, and grounding cables have been correctly connected.
•
The input power voltage meets the requirement of the switch.
•
The console cable is properly connected, the terminal or PC used for configuration has started, and
•
the configuration parameters have been set.
33