Installation Procedure - HP A10500 Series Installation Manual

Figure 16 Power supply installation flow

Installation procedure

CAUTION:
When moving the power supply, support the bottom of the power supply, instead of holding its
•
handle to avoid damaging the power supply.
To install the power supply:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded. For more information, see
Use a Phillips screwdriver to loosen the captive screws on the blank panel (if any) to remove the
2.
blank panel.
Unpack the power supply.
3.
Follow the installation graph printed on the blank panel of the power supply to install the power
4.
supply in a correct direction. Grasp the handle of the module with one hand and support the
module bottom with the other. Push the power supply along the guide rails into the slot until it has
firm contact with the slot. For vertical slot installation, see callout 1 on
installation, see callout 1 on
Press the handle inward until the handle seats into the slot.
5.
As shown in callout 2 on
6.
handle to attach the power supply.
"Attaching an ESD-preventive wrist
Figure 20.
Figure 19, use a Phillips screwdriver to fasten the captive screw on the
18
strap."
Figure 19. For horizontal slot